Move Bays

image

Move Bays with Mouse

image

You can move bays with the mouse.

1.      Click on the Edit Bay tool.

image

2.      Select the bay(s) to move (see Select Bays). They (It) become(s) highlighted and a move pointer is displayed.

3.      Press and hold the mouse button with the pointer over the selected bay(s) and move the mouse to the desired bay position.

4.      Release the mouse button.

5.      The way the bays are moved depends on the state of the Free Bays (Bay Placement Mode):

image

·         With Free Bays On: The bay(s) is (are) moved at the selected position on the ground. If there are one or more other bays at this position, they may overlap.

bays are moved to 1 cm (or 0.5”) rounded position values.

To move the bay(s) completely freely, you can hold the space bar while moving, producing a slower motion and preventing position rounding.

image

 

Note: You can also specify precise values. See Enter Bay Position.

Enter Bay Position

image

In Free Bays mode, you can position bays with precise values:

image

Position Y: the distance from the position 0 along the Y axis. The position 0 is shown by an indicator with the Y axis in green in your planogram when the Edit Bay tool is active.

Position Z: the distance from the position 0 along the Z axis (vertical distance from the ground). The position 0 is shown by an indicator with the Z axis in blue in your planogram when the Edit Bay tool is active.

 

Note: Each bay position is calculated from the lower edge of the bay at the mid-point of its width.

See below an example of a bay with the reference point and axis shown.

image

 

Tip: You can select several bays and apply common new values to these bays together.




PlanogramBuilder Light User Guide - © Copyright zVisuel, 2001-2020